Dave,
I am trying to think of how you might test it.
The best I can think of is to listen to both a noise source and an XG3
sending a CW string of dots. Increase the speed of the CW sent by the
XG3 until you can no longer hear the noise source between dits.
Then either calculate the off times for the dits or measure it on an
oscilloscope.
73,
Don W3FPR
On 1/13/2019 2:07 PM, Dave Cole (NK7Z) wrote:
Hi again Scott,
Thank you for your answer, but I am not being clear.
Not during break in, just sitting there in receive... If the radio is
hit with an S9+ signal, how long after the S9+ signal terminates before
the K3 receiver recovers enough to show an weak signal on the IF... No
T/R happening, just sitting there in receive.
You are close to what I am looking for... I am investigating the
possibility of using the K3 as the receiver portion in a homebrew
bistatic radar setup running in the HF spectrum.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
