Hi I am building K2 #5538. All was going well until I got to the PLL upgrade kit. By all the previous emails I have figured its an engineering change. My two questions are:
1. Can I use solid wire to mount/connect the upgrade board to the RF board, vice the green stranded? 2. Because there is no cladding on the front side, can I bend the wires around the edge of thethe board edge and make the board sit directly over the installation holes of the now defunct RP3? This would preclude the board sitting flat on the RF board. I dont' want to find later when I install a daughter board the extra height of the pll upgrade would get me into trouble. There is not much room to fit this into the space previously occupied by RP3. The color pix in the pdf file on line seems to show solid wire, as I don't know why you would want to fight coaxing all those strands into those holes (tried tinning). Wiring the optical encoder by wrapping stranded wire around the posts was bad enough, I'd have used solid wire... I set the upgrade board aside until after the mounting of U6 and RFC 14, figured it was easier to mount those before I "shoe-horned" in that upgrade board... Any suggestions?? Thanks R. Linder wb7ond _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
