Wolfgang,
Connect K60XV J2 pin 2 to a jack and you will have an Amp Keying output.
There is just barely room to mount an RCA jack on the lower rear panel.
Look for a clear spot near the Key jack and drill a hole as close to the
top of the panel as possible while still allowing the jack to not
project above the top of the panel.
73,
Don W3FPR
On 1/20/2019 8:15 AM, Wolfgang Peringer wrote:
Hello:
I have built and installed the K60XV 60m and transverter adapter in my
K2. I was using the 8-pin female connector (RF-J13) for my amplifier
keying circuit (N0SS design). As this connector is now used for the
KX60XV I am looking for a way to key an external amplifier.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
