I agree with Rick just keep the drive power to the minimum needed to get the 500 watts out. Over driving will do nothing but distort the signal and most likely eventually damage the amp. I use 18 to 20 watts to get 500 out on 160 mtrs and a bit more to get same results on the higher bands. Bruce WW8II
On Thu, Feb 28, 2019 at 1:08 PM Jim Lageson <[email protected]> wrote: > I have never owned an amp before and recently put together a KPA500. All > seems to be working well, but I have a few questions. I am using with a > IC-7300. > > How important is the ALC cable? I notice it is not included in the Basic > Cabling Diagram in the manual but is discussed later in the manual. > > If I were accidently to run 100 watts into the KPA500 will the PWRIN HI > Hard Fault/STBY protect itself before any damage is done. Would ALC protect > me from that? > > Is it standard procedure to keep the KPA500 in line when turned off and not > in use? I see you may run up to 200 through the KPA500 in STBY. > > Is there any concerns or settings on radio when running full break in on > CW? > > Thanks > Jim-N0UR > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
