A question if you please.
I am assembling a K-2. At present, I am currently in the Alignment and
Test section, Part II. Page 65 covers the BFO test where you use Band+
and Band- to check for BFO range. When I press Band+, the frequency
counter initially reads around 1.480 MHz and starts increasing in
frequency. I am guessing about 100 kHz per minute. When I press Band-,
I get a good reading of 4.911 MHz. All of the other checks thusfar in
this Part II have been good. This is puzzling and I hope someone can
give me some ideas.
Thanks,
Bill KC5MN
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
