Tom,
As instructed in the KAT1 manual, refer to page 31 of your K1 manual and
see if R39 is present. If not, add it. In either case, solder C76
across R39 - one capacitor lead to each resistor lead.
Do the trace cut as shown in the diagram on page 8 - I can't describe it
better than the pictures. Install R4 as shown in the diagram.
You can make those RF Board changes at any time - except for removing
the end of R36 - wait until you install the KAT1 for that part.
73,
Don W3FPR
On 3/20/2019 4:39 PM, Tom Johnson wrote:
Before I go cutting into the RF Board (Revision D, year 2000) and soldering
resistors and capacitors together, I want to clarify my understanding.
1) Does "Solder capacitor RF-C76 across RF-R39.." mean that I leave RF-R39
soldered to the board and additionally solder the leads of RF-C76 onto the
leads of RF-R39 on each side?
2) I do CUT the trace the right of "DRV" and install RF-R4 between the
trace's contact points?
3) I'm at this point only through Part I of the RF Board assembly and
alignment - I have already built the 4 Band Filter Board (KFL1-4, Revision
B), and KAT1 Revision C. I'm assuming I do NOT prep the RF Board and
install the KAT1 board until I've completed the assembly and alignments of
the RF and Filter Boards?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
