Hi All, I need some suggestions on where to start trouble shooting. I looked at Nabble and I have checked all that is listed there and no luck.
The sub receiver was working perfectly. I took the radio apart to add some new filters to the sub receiver. It originally had two of them; configured as 2.8Khz, then a 400Hz right next to it, and then 3 blank slots. I removed the 400Hz, the the filters are in the following order; 2.8Khz, blank slot, 1.0Hz, 400Hz, and finally 250Hz in the 5th slot. I used the K3 utility to configure them, with the appropriate settings for each filter. When using the radio, I have both the main and sub receiver on the Main antenna. If I tune to a strong signal on the band, using just the main receiver, I hear on both sides of the headphones. When I engage the sub receiver, I still hear the signal in the left ear, but the right ear goes to just white noise. When the sub receiver is engaged, I can hear sounds in the left ear when pushing any buttons on the radio. I am somewhat stumped, as I was very diligent in disassembly and then re-assembling it. Using most current firmware, 5.66. Please advise. 73 de Jim - KE8G ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
