Arie, First, welcome and congratulations on becoming a new ham.
If you look at the value of R18 and R19 (on the schematic), you will find they are zero ohms - in other words, the jumpers are the 'resistors' - you will find no zero ohm resistors in the kit parts, simply use jumper wires. Note that these 'resistor' jumpers will be removed if you add either the KAF2 or the KDSP2, so consider carefully the mounting of these jumpers and mount them on whichever side will allow the easiest removal for you. 73, Don W3FPR > -----Original Message----- > > Need some clarification: > > I'm building the K2 and currently at the control board > (page 17) and need to install R18 & R19 but can not > fully understand if I also need to make short > (jumpers) above those resistors at the top side of the > board. What is the purpose of those shorts . I guess I > understand wrong or there must be a cerain reason. > > Thanks for all the help. > > New HAM from Tokyo. > > Arie > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
