I am performing a K1 transmitter offset alignment as described on page 47 of the manual (Rev C, October 9 2000). According to the manual I should install a jumper between the two "OFS" pads, disable AGC, set output to 1 watt, and enter Tune mode. At that point I should hear two tones - a sidetone, plus a transmit monitor tone.
I hear neither. If I key the paddles, I hear the side tone. But Tune mode doesn't produce any sidetone, nor can I hear the transmit monitor tone. Any ideas? _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
