LIN OUT is already set at 1. The Microphone level set and extra attenuator steps in W7 are not active until you plug a microphone into the MIC jack and has no effect on the K3S internal sound card whuch shows up as its own COM device.
Hank K7HP Message: 9 Date: Wed, 3 Apr 2019 17:29:58 -0500 From: Bob McGraw K4TAX <[email protected]> To: [email protected] Subject: Re: [Elecraft] K3S USB sound card -W7 pro Message-ID: <[email protected]> Content-Type: text/plain; charset=utf-8; format=flowed Also, in the Windows 7 sound card? make sure your don't have Microphone Boost checked.??? Forgot about that one. 73 Bob, K4TAX On 4/3/2019 5:21 PM, Bob McGraw K4TAX wrote: > If you go into the K3S CONFIG menu to LIN OUT the normal value is > 10.?? I suggest you back this down to 5.? This will then allow the > Windows 7 Pro sound card slider to operate near mid range thus? 0 dB > or 50% depending on how it is displayed. > > 73 > > Bob, K4TAX > > On 4/3/2019 4:50 PM, HP wrote: >> Is here any way in W7 to change the RX level when using the built in >> USB K3S sound card . The W7 slider >> goes to -10dB with a lot of care but next tap is -192 dB- In WSJT >> this means I have LIN out set to 001 and its. still a bit too high .? >> >> Hank K7HP ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
