It's the I/O RJ45 connector on the back of the 1258, pin 4, that will
key the remote radio, I use it with a Winkey3. Pin 8 it ground, and
while it is documented in a combination of schematic and pin-out
diagram, it is, as Rick says, decidedly non-obvious.
73,
Fred ["Skip"] K6DGW
Sparks NV DM09dn
Washoe County
On 4/15/2019 8:53 AM, Rick Tavan wrote:
I use an external CW keyer at the control site and inject keying
into the RRC through a rear-panel connection, documented but non-obvious.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
