Mark,
First check the DC voltage on U6 pin 5. It should be near 4 volts - if
not, you have a problem on the thermistor board, likely a solder bridge.
Then recheck the PLL reference oscillator range at TP3 using CAL FCTR.
Tell me the high and low frequencies.
Then check the VFO frequency at TP1 (using CAL FCTR) when tuned to
4000kHz and again when tuned to 7100kHz.
73,
Don W3FPR
On 4/21/2019 1:43 PM, Mark Yergin wrote:
I'm getting 0.02 V at R30, not 6V. Turns on T5 correct and wound per
image. Reflowed the four solder joints and verified continuity between 1
and 2, 3 and 4. C72 is correct value (label 271) and reflowed. L30 is the
correct value (large slot), and reflowed. D21-26 confirmed as correct
values. C71-74 confirmed as correct values.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
