Hi Folks,
I am having an issue with the band data out from the K3s and K3S. Both
have are basically new. The K3S was NEW in Aug 2018 and the K3s had the
I/O board replaced at the same time. Both units have the same issue.
They don't seem to be able to drive band data input of a couple of
antenna switches. The one switch has a 1K input resistor. If I change
them to a 100 ohm resistor, they work fine.
So my questions are:
Is this normal?Should the band data work on the newer gear?
What am I missing?
Can someone tell me what to do?
yes, I know about the 2.2K resistors, but should I need to?
TNX Will WC2L
--
William Liporace WC2L
http://www.wc2l.com or http://dxc.wc2l.com
AR-Cluster Node telnet dxc.wc2l.com or 144.93 MHz
[email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
