If/when implemented how would the REM ANT control communicate with the 
controlled device?

73

Jim ab3cv 

> On May 28, 2019, at 11:53 PM, Wayne Burdick <[email protected]> wrote:
> 

> n6wg <[email protected]> wrote:
> 
> There are 5 rx ant ports on the K4, 3 UHF and 2 BNC.  I've seen no mention of 
> how they are to be selected though.  In my imagination, I see pressing the RX 
> ANT button putting a list of up to 5 antennas on the screen.


This is pretty close, Bob. There are actually four antenna controls on the K4:

  ANT (tap)        Selects the transmit antenna (if a KAT4 is installed: ANT 
1/2/3)
  REM ANT (hold)   Might be used to control a remote antenna switch, rotator, 
etc. (future)

  RX ANT (tap)     Selects the main RX antenna (default: TX ANT)
  SUB ANT (hold)   Selects the sub RX antenna (default: TX ANT)

When you tap RX ANT or hold SUB ANT, you'll get a pick list of all available 
antennas for that receiver. In the case of the K4D or K4HD, you can make 
independent selections for these, because they both include the diversity 
option module (with a second ADC, second set of band-pass filters, and separate 
set of of RX antenna relays).

The default antenna for both receivers is the selected transmit antenna. This 
means the signal goes through the KAT4 ATU and its antenna switch (ANT 1, 2, 3).

The other possible receive antenna choices are:

  RX ANT 1
  RX ANT 2 (which doubles as XVTR IN)
  Either of the two KAT4 *non-transmit* antennas 

ANT 4 is reserved for use with the future VHF/UHF module. The connector could 
be UHF or N.

73,
Wayne
N6KR
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

Reply via email to