All,
I am trying to bring a Drake L-4B to life. I have done the power supply
rebuild, the soft-start and other mods. I have also directly grounded
the grids of the 3-500Zs (Eimac brand). In driving it with my K3 (SN
51XX, software up to date) I find that the RF power stair-steps to the
set power in a hesitating way over a few seconds. This happens sending
Morse code or using the "Tune" button.
The supply voltage, as monitored on the K3 display, is at about 13.4
volts when transmitting.
I have a power/SWR meter between the K3 and the amp and it shows a low
SWR at all times, as does the K3 SWR meter.
The power meter between the K3 and the amp shows the power gradually
increasing. As the K3 increases power out, the amp power out increases
in a similar fashion.
I see no indication of oscillation. The power meters on the output side
of the amp show no power when the amp is keyed but no RF is supplied. I
placed a low-pass filter (41 MHz cutoff) between the K3 and the amp to
no effect.
I notice that if I send a series of Morse code characters such that the
K3 transmit delay timer never times out, once the power ramps up to the
set value, it remains solid until the timer expires - when I start
transmitting again, the power step process repeats.
When I put the amp in Standby, the K3 functions normally.
This smells like an oscillation problem, but I see no evidence of one.
Any advice would be appreciated.
Thanks,
Bill K5EMI
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
