If you'd like to tackle a DIY project, take a look at the FreqEZ Band
Decoder project.
http://hamprojects.info/freqez/
Decode by: BCD output, Radio Frequency, or up to 250 Band Segments16
SPDT relay outputsNo DIP switches, diodes, solder-bridges. All
configuration is via software settingsFree software. You buy your
hardware from your favorite sources
Watch a short (5 minutes) FreqEZ Overview video HERE
<http://hamprojects.info/hamprojects-download-page/#elf_l1_RnJlcUVa>
(FreqEZ Overview_Video.MP4)
-larry (K8UT)
------ Original Message ------
From: "Evert Bakker" <[email protected]>
To: "'elecraft Reflector'" <[email protected]>
Sent: 2019-06-06 11:32:02
Subject: Re: [Elecraft] band decode/antenna switch controller
A Q abt the KRC2:
Is it possible two switch to two different antennes within one band but
based on frequency span ?
Example:
3.500 - 3.650 Mc Antenna 1
3.650 - 3.800 Mc Antenne 2
73's, Evert PA2KW
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
