I have an external amplifier that can follow the band changes on the K2 by reading the frequency data from the serial output. To enable this the command AI1; needs to be sent to the K2 first.
The issue is that if the K2 is powered off the command AI1; needs to be resent again at power up since it will not survive a power cycle. Is there a way to permanently set the AI1 Parameter? If not it appears a solution may be to program a small micro controller to send that command upon power up (with a small delay). Thank you. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
