Paula,
Although you said 'it worked before', take a look at the ALC meter.
With digital modes, you should have enough audio to drive it to 4 bars
with the 5th bar flashing. See the article on my website www.w3fpr.com.
Can you transmit in SSB mode? If so, the K3 audio is fine and you can
focus on the Line In or the soundcard output for the problem source.
73,
Don W3FPR
On 6/24/2019 9:29 AM, Paula Uscian wrote:
I suspect I may have an issue with the Line In port of my K3, as my ability to
TX in any digital mode has gone away.
Setup:
1. Using a Tascam US-122 MKII outboard sound card.
2. MIC SEL is set to Line In on the K3.
3. Digital software, e.g., WinWarbler and WSJT, have the Tascam selected for TX
and RX.
4. Mode selection for FT8 is set to Data, for RTTY is set to AFSK 45 bps.
5. Levels are the same as when this system worked – K3 Mic level is set around
43-44.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
