Yes Andy, I used a TS590 at field day. But this is the Elecraft reflector. These rigs work differently. Use my K3 for FT8 often. I built an interface for my Kenwood rig too. But you treat them differently.
Jim Rhodes K0XU On Fri, Jun 28, 2019, 11:21 Andy Durbin <[email protected]> wrote: > I strongly disagree that ALC should be zero for FT8 but that is based only > on my experience with the TS-590S. > > My draft paper on FT8 harmonics can be found here - > > > https://www.dropbox.com/s/85aoc937kz235iq/FT8%20audio%20harmonics%20draft%20d%20k3wyc.pdf?dl=0 > > ALC must be in the control range for closed loop power control to work on > a TS-590. Operating in the normal ALC range with a TS-590 does not degrade > the F8 signal. > > 73, > Andy k3wyc > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
