Skip,
Make certain the K3 is getting audio into the Line In jack.
Pull the speaker or Line Out cable from your soundcard and plug
headphones or amplified computer speakers into that soundcard jack.
Then do a TX from your software application. Do you hear any audio
tones? If not, check the computer/soundcard.
If audio there, plug in the cable to the K3 Line In making sure the
plugs are fully seated on each end. You could have a bad cable.
Since you have good audio to the computer on RX, swap the two audio
cables between the soundcard and the K3. If you have an OK waterfall
display, the cable between K3 Line Out and soundcard line in (mic) is
working.
If you still have problems, contact [email protected] for further
analysis.
73,
Don W3FPR
On 6/30/2019 11:43 PM, Skip Cameron wrote:
While using my K3 in data A mode with wsjt-x software on 6M, TX stopped,
and other data modes also have no TX output. RX remains OK, and CW and SSB
TX & RX still work OK.
Need suggestions on diagnosis or reset process. Direct replies off list
are OK. Thanks, Skip W5GAI
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
