>
> While using my K3 in data A mode with wsjt-x software on 6M, TX stopped, and
> other data modes also have no TX output. RX remains OK, and CW and SSB TX &
> RX still work OK. Need suggestions on diagnosis or reset process. Direct
> replies off list are OK. Thanks, Skip W5GAI
> I occasionally have rf get into the laptop and blow it out of the water and
> everything including the above symptom results. A reboot of the laptop and
> K3S restart after moving some wires around usually fix it. In my case, better
> bonding and judicious use of ferrite would cure the problem. I'm still in a
> "temporary" mode with the station build :-). I'll get there!
>
> 73
> Bill WE5P
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
