John,
The recommended troubleshooting steps in cases like this is to remove
everything from the K3 except the power cable and the coax to a dummy load.
With that done, does the problem still appear - if so contact
[email protected].
If it does not appear, then plug things back in one at a time to see
which external device is causing the problem.
73,
Don W3FPR
On 7/4/2019 9:34 PM, John and Rita Freitag via Elecraft wrote:
I am trying to run down a CW transmit problem on my K3s. Anytime I change the
mode from LSB or USB on any band to CW it starts to send a “dit” without
stopping and I have to halt it by restoring the configuration. This does fix it
until I try to switch to CW again; and then, the same story.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
