Thanks Mike and I have Squelch working. Paul
> On Jul 6, 2019, at 8:07 PM, Michael Walker <[email protected]> wrote: > > You have to be at the following revision: > > > Rev. A6-2, 15 December, 2017 Copyright © 2017, Elecraft, Inc. All Rights > Reserved > > FM Mode FM Mode > > This added mode is intended primarily for use on the 10 meter band, and > repeater as well as simplex > operations are supported. External transverters may also be used (see KX2 > Owner's Manual for set up). > > - To enable or disable FM mode's availability, use MENU:FM MODE. VFO A > controls FM on/off. If FM mode is > enabled, it is available on all bands. > > FM mode must be selected in order to use the controls shown below. > - To adjust squelch, tap FIL and rotate the AF GAIN knob. > - To adjust transmit offset frequency (repeater shift or split), use MENU:RPT > OFS and VFO A. Offset values can > be set at 20 KHz increments. > - To select transmit frequency offset direction, hold SPLIT. The transmit > offset direction (+/-/SIMPLEX) will be > shown on the VFO B display, alongside the transmit offset value. Successive > holds of SPLIT will rotate > through the three offset directions. > - Transmit offset and direction are remembered on a per-band basis. Saving an > FM mode memory stores > both. > - FM deviation may be changed with MENU:FM DEV. Use VFO A to set it. You > might have to unlock this > setting in order to change it. Hold the FREQ button down for 3 seconds to > clear lock status. > - PL (CTCSS) tone deviation may be adjusted from within MENU:FM DEV. While in > this menu, tap '1' to select > PL deviation. It can then be changed by rotating VFO A. > - PL tone frequency may be adjusted using MENU:FM TONE. Tapping '1' turns PL > tone on or off. If PL tone is > turned on, rotating VFO A changes its frequency. > - 1750 Hz tone burst is not supported at this time. > > Mike va3mw > >> On Sat, Jul 6, 2019 at 8:23 PM Paul Gacek via Elecraft >> <[email protected]> wrote: >> I’m trying to get an XV144 working for possible SOTA usage. >> >> As I might be operating FM and/or SSB I’ve been searching for squelch >> control on the KX2 but without luck. Does it support squelch? >> >> Paul >> W6PNG/M0SNA >> www.nomadic.blog >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
