Good day I am trying to use the buttons on the K-Pod to run macros. I have used the K3 Utility Command tester to store the macro (in this case swt42;) and edited the MACRO15 label to SPOT. So a tap of the F7 button on the K-Pod should tune the rig to the signal (CWT on, signal is close enough). I have written the macros to the K3, and confirmed they are there by erasing them in the macro editor, and reading them back from the K3. Running the macro from the Command tester works as expected.
Tapping F7 on the K-Pod gets the macro label appearing in the VFO B area and a 'bip' from the K-Pod, but no evidence that the swt42; is being actioned; nothing happens to the rig. Although this is perhaps a simplistic example, it demonstrates the problem. I did find I was able to get the F7 button on the K-Pod to work by programming Function 7 through the CONFIG:MACRO menu option and assigning a tap of the SPOT button to that Function. However, I want to go on to control the P3 by using its macro commands (#QSY1; and #QSY0;), which as far as I am aware, cannot be assigned through the CONFIG:MACRO options. (Testing the #QSY1; and #QSY0; commands from the Command tester works just as I wish). Firmware in both the K3 and K-Pod updated today (9th July 2019). I guess I have overlooked something simple. Any advice would be appreciated. Peter M0RYB -- Sent from: http://elecraft.365791.n2.nabble.com/ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
