Hi Gary could you perhaps chose 2 transverters 144MHz and 145MHz and set the levels accordingly? Fortunately all my transverters have a 28MHz IF. Another Elecraft 'surprise'. The worst one for me is the K3S TX IMD on 6m, its really quite awful and not good enough for me to use. So I suppose that I will end up using the transverter port for 6m as well. Its a shame because the RX is outstanding.
You will love the performance of the Kuhne transverter with the K3, its the best combination that I have found for the band. 73 Conrad PA5Y ________________________________ From: [email protected] <[email protected]> on behalf of Gary Johnson <[email protected]> Sent: 09 July 2019 06:10 To: [email protected] Subject: Re: [Elecraft] XVTR Out level Sure enough, the BPFs are in the low-level RF path on TX and RX. Moral of the story is to choose a transverter with a 28 MHz IF when maximum usable frequency range is desired. Gary NA6O ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
