From what I’ve read, you have an open circuit to the antenna. Feedline okay? I had a marginal feedline and had to replace it.
I also had a bad BNC cable that deformed the connector on the side of the KX3 and had to replace it as well. On Sat, Aug 10, 2019 at 12:29 Aaron <[email protected]> wrote: > I have a KX3 with the ATU installed. I replaced the batteries and since > then the ATU will not tune. When I hit the ATU TUNE button it just says > 25.4-1 and I can hear the relays going off. I opened it back up and looked > for any cables not connected or anything and it looked all fine to me but I > could have missed something. It was working just fine before the battery > switch. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > -- 72, Rich Hurd / WC3T / DMR: 3142737 Northampton County RACES, EPA-ARRL Public Information Officer for Scouting Latitude: 40.761621 Longitude: -75.288988 (40°45.68' N 75°17.33' W) Grid: *FN20is* ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
