The long quote is not describing the difference between "Rig" and "Fake It". It is describing the difference between "Rig" or "Fake It" (either one) and "None". It is the difference between having some method to QSY the radio between RX and TX (either "Rig" or "Fake It" can do that), and not QSYing the radio between RX and TX.
The difference between "Rig" and "Fake It" is simply in how the radio is QSYed. "Rig" uses the radio's Split capability to switch frequencies between RX and TX. "Fake It" actually QSYs the main VFO between RX and TX. The reason "Fake It" is suggested is due to the way WSJT-X verifies whether the QSY has taken place. With some radios and some rig control methods, WSJT-X takes so long to turn split on and off and verify split status that it turns out that simply QSYing the main VFO is faster. Try them both, and take special note of how long it takes from the beginning of a transmit cycle until the rig actually starts transmitting. If "Split" takes noticeably longer than "Fake It", then use "Fake It". 73, Rich VE3KI N4SRN wrote: I'm using a KX2/KXPA100 at 40W on a Win10 laptop with WSJT-X 2.1.0 for FT8. Antenna is a G5RV at 40ft with base ATU 150ft away. I've been advised elsewhere that "Fake It" is a better choice than "Rig" for Split Mode: "it depends on what filter the radio has. Most are 2.4Khz (300-2700). If so you would most likely need to be between around 600 to 2300. It also depends on the skirts of the filter on where power will drop off and you can maybe have harmonics. If you want to limit your transmit audio to 1500-2000 you may not be able to find a clear place to transmit. If you have CAT control then fake it automatically will adjust your transmit audio frequency to be in the sweet spot of the filter." I understand the KX2 filter is DSP Filtering‎: ‎50-4000 Hz, so am not sure about using "Fake It" or "Rig" and would appreciate comment. Thanks! Bret/N4SRN ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
