Hi Ilya, This might be possible. Take a look at it he K3 schematics. Before I found a KXV3 I was considering this, certainly the IF out.
As I recall on the main board there is a connector with the rf in and out. These are jumpered on the main board when no KXV3is fitted. Then there should be a control signal to switch the relays for rx antenna routing. I think if you are reasonably technically proficient you can produce a way to make this work for you. You can probably do away with the relays if you use a jumper or manual switch when you don’t want the rx in-outfunction. Martin, HS0ZED Sent from my iPad > On 4 Oct 2019, at 03:10, Ilya <[email protected]> wrote: > > Hi mates! > > Is there a way to connect an RX antenna without using a KXV3 option? > I've got an IF-output socket connected directly to P86 on RF board on one > of my K3's, maybe there is a similar way for an RX ant? > > Thanks and 73! > Ilya R3XA > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
