"Does it really power off the KPA and power it back on?" The KPA500 states are:
Unpowered - power not connected or rear power switch off. It does not respond to anything. Powered but Off - Power is connected and rear power switch is on. Responds to a few serial commands including power up (I assume also responds to power pin) STBY - front panel switch is selected On and standby mode is active OPER- front panel switch is selected On and operate mode is active Firmware loading mode not included in list. See KPA500 Programmer's Reference for more detail. 73, Andy, k3wyc ________________________________ From: Andy Durbin Sent: Monday, October 21, 2019 8:59 AM To: [email protected] <[email protected]> Subject: KPA500 and KTA AUX Cable/Remote "My question is since I do not have the KPA and KTA connected to a K3 (it's a K'Wood TS-480), do I really need the aux cable between the KPA and KTA?" Aux cable not required and would, to the best of my knowledge, do nothing in your configuration. What you probably can do is have the KPA500 poll the TS-480 with IF, FA, and FB and have the KPA500 and KAT500 listen to the replies. (I only say probably because I assume, but don't know, that the TS-480 supports IF, FA and FB responses. It works for TS-590 and TS-890). Elecraft sell a serial cable for exactly this purpose. Be aware though that KAT500 will only follow VFO A if you use this configuration. KPA500 will follow the TX VFO regardless of whether that is A or B. Sorry, but I have no experience with the power up pin. 73, Andy, k3wyc ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
