The Elecraft K3s manual states over and over that the RF gain should always be wide open. I had been running it at about 12 o'clock on FT8 for some time before this was brought to my attention. I supposed that 100% RF gain could possibly show me weak stations I’d not seen before, so I’m trying it.
In order to keep the Audio Input to WSJT FT8 at a reasonable level (nominally 40dB: noise only) with the K3s RF gain wide open I have to run the SignaLink’s RX way down near full CCW. Very touchy and hard to adjust. SignaLink’s JP2 jumper is NOT connected. I do NOT use AGC, nor do I wish to. Oh, this is a Mac so the USB Audio Codec input has no level adjustment. Any suggestions as to what I might do to get SignaLink’s RX back to about 12 o’clock where it used to be? Please reply to [email protected] Cheers! Richard Kunc - W4KBX ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
