Hi,
after I finally installed the KAF2 module in my K2/100 05775, it was
time to do a complete alignment and I ran into this old problem again.
The output power at 160 m is 100 W. And drops from band to band to 80 W.
Now I have adjusted the KPA100 to 10m. Now I have there 100 W but then
on 160 m 120 W.
Measured with an LP-100A and dummy load. SWR is fine!
It looks as if the whole power measurement shows a certain skewness.
Any hint?
73s, Holger DL9HDA
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
