Great, I'll take that answer! It seems to be working just fine, so now I'll just have to remember to check that calibration more frequently.
Thanks again, Don! 73, Jim KO5V -----Original Message----- >From: Don Wilhelm <donw...@embarqmail.com> >Sent: Nov 12, 2019 12:41 PM >To: Jim KO5V <jrf1...@earthlink.net>, elecraft list <elecraft@mailman.qth.net> >Subject: Re: [Elecraft] K2: KPA100 Trouble > >Jim, > >Likely nothing wrong. If the K2 is ever powered when that menu >parameter (which follows the heatsink temperature) is set to a low >value, the parameter will try to go below 0 degC - but the math cannot >handle negative values, so it instead goes to a high value. > >It is wise to check the CAL TPA parameter periodically if one has the >KPA100. > >73, >Don W3FPR > >On 11/12/2019 2:28 PM, Jim KO5V wrote: >> Hi again Don, >> >> I just finished that. I found the setting to be 143C. something must be bad; >> possibly R6 or the temp sensor? >> >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com