As to the beep every 7 seconds, I see that on my P3. It is a tuneable
signal in CW mode, however it does not appear when the antenna is
disconnected from the radio. Therefore, it would seem to be coming in
on the antenna. One of those UFO's, space aliens, or other one eyed
monsters.
73
Bob, K4TAX
On 11/12/2019 2:37 PM, Bob McGraw K4TAX wrote:
Go to the Config Menu and check BND MAP settings. This says you
have blocked or mapped 14.0 out. See page 58 of the manual.
73
Bob, K4TAX
On 11/12/2019 1:50 PM, Jim Danehy wrote:
I recently moved my K3, KPA 500 and KAT 500 to a new place in my
home. It was working perfectly before the move.
I hooked everything back up. All cables properly attached.
Now on 14.025 I get a tone every 7 seconds. Just a beep. It probably
is 900 hertz. It comes like clockwork. It only does that on 14.025.
It is a single shirt burst,
Now when cycling through the bands using the KPA buttons it avoids 14
MHz.
I am looking for an explanation and assistance on how to correct the
unwanted short burst
73
W9VNE
Sent from my iPhone
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
