Thanks, Ken. I didn't think to check the firmware release notes. That
feature was added in 2017.
73,
Scott K9MA
On 11/17/2019 16:39, Ken K6MR wrote:
I think you are looking for the Tx line out monitor level. LIN OUT
(from Config menu) and press 2. 0 should give you no monitor output.
Ken K6MR
*From: *K9MA <mailto:[email protected]>
*Sent: *Sunday, November 17, 2019 14:29
*To: *[email protected] <mailto:[email protected]>
*Subject: *[Elecraft] K3 Monitor on Line Output
On SSB, I have the monitor level set to zero, and hear nothing in the
headphones. However, when I record the audio from the line outputs, I
get my own audio when transmitting, at a much higher level than the rx
audio. (LIN OUT nor 050) (No, it's not the mic on another headset
connected to the computer.) I can't find anything in the manual about
this. At the very least, it would be helpful to be able to match the
levels of the TX and RX audio. Am I missing something? Any suggestions?
73,
Scott K9MA
--
Scott K9MA
[email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
--
Scott K9MA
[email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
