Victor's point is a good one. Thus the question are you working full
QSK or semi-QSK? If the TX Delay is long, default is about 8 ms as I
recall, it will put in the required space for the correct timing to key
an external amplifier. This can occur between every CW element in QSK
mode. Also there is a Menu value for higher speed CW as opposed to
what us old slow folks use.
73
Bob, K4TAX
On 12/3/2019 3:33 PM, Victor Rosenthal 4X6GP wrote:
Do you have CONFIG:TX DELAY set higher than 8 or 10?
73,
Victor, 4X6GP
Rehovot, Israel
Formerly K2VCO
CWops no. 5
http://www.qsl.net/k2vco/
On 03/12/2019 18:38, Keith Lamonica wrote:
Am I just missing a setting. With my K3 CW is fine up to about
23wpm. Any higher speed results in just spacing change In
e.g.
I have n1mm cw working fine ….… keyboard on software sends qrq fine …
n1mm sends qrq fine … paddle is stuck at about 20wpm … if I jack up
the speed it increases the character speed bust adds a space so speed
does not do up and it sounds like crap… anything I can do?
John k9dx
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
