I understand that the ATU uses 10 kHz segments on 80, which was at some
point changed from 20 kHz. That means the center points are 3505, 3515,
etc. There is some hysteresis when tuning, but I'm not sure that
consistently explains where it switches. It also won't switch until you
stop tuning for 1/2 second, or so.
Another factor is that the ATU only measure frequency to, I think, 8
kHz. The net result may be that sometimes it's not in the frequency
segment you think it should be in. Unless you have a very narrow band
antenna, it shouldn't make much difference.
73,
Scott K9MA
On 12/10/2019 17:03, [email protected] wrote:
After saving my KPA-1500 ATU impedance matching parameters on 80M at
20 Kc intervals (3.510, 3.530, 3.550, 3.570, etc, etc), I expected
that the KPA-1500 ATU would automatically switch to the next set of
L/C values at the midpoint of the 20 Kc segments (like 3.520, 3.540,
3.560, etc, etc), but I find that it switches randomly, sometimes just
2 Kc away from the main tuning frequencies. Does anyone have
information on how the ATU is supposed to work when it is polling the
xcvr for frequency?
Thanks, K5UA
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
--
Scott K9MA
[email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
