I have been using an Astron SS-30M power supply for several years to feed two K3's. I use 12ga wire from the power supply to an MFJ-4012 power strip. From the power strip I use 12ga wire to each K3. Total length from power supply to a K3 was 8'. Each K3 is set for 100W on 30M into a dummy load. The K3's were tested one at a time. The power supply voltage went from 14.38 to 14.30 at 100W. Both K3's read the same on the K3's internal voltmeter - 14.1V in receive and 12.7V at 100W setting on the K3's. The P3 read 107W out. Changed the cable to 10ga wire direct from the power supply to each K3. Length of each is 7'. Same test. Power supply voltage was still 14.39/14.30. Voltage on each K3 was now 14.2v. Key down 13.6V. So, 0.6V drop in 7' of 10ga wire. P3 output was now 114W. I never transmit with both K3's at the same time. Just a data point. 73 and Merry Christmas N2TK, Tony
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
