From the amp MENU, scroll to SPEAKER, then press EDIT, and set to ON
or OFF as you prefer. This will give you a beep when you switch from
STBY to OPER. It also controls the FAULT annunciation as heard via the
radio if set to ON. See page 19 in the KPA500 manual. This IS NOT
controlled via the radio. You will hear a beep when any button on the
KPA500 has been pressed. I certainly would not describe this as
"feedback tone".
73
Bob, K4TAX
On 12/27/2019 7:11 AM, Richard wrote:
Whenever I push a button, any button, on the KPA-500, for example, to go from
STBY to OPER, I hear an audible feedback tone. Very annoying.
I’ve discovered that by setting CONFIG:SW TONE to OFF, it goes away… but then
so do all the other tones the radio produces, tones I DON’T want to silence.
Do I have any other options?
Cheers.
Richard Kunc ~ W4KBX
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
