As a rule I set the REF LVL such that the no signal band noise is about
the bottom of the display. Then I set the SCALE to display the
strongest signals on the band at the top of the display. These will
change from band to band and antenna to antenna.
Otherwise, with a dummy load on the receiver and the BW at 2.7 kHz, set
the REF LVL to about 120 and the SCALE to 80. Set the AVERAGE value
to about 15. These seem to give adequate display. Of course one can
refine the values for more or less displayed details of the signals,
depending on BW of the receiver.
73
Bob, K4TAX
On 12/28/19 13:13, kd2fsh wrote:
If somebody can help me what are the best settings for Re Level and
Scale? I just move to Arizona from New Jersey and put up an EndFed
Antenna.Thank youJerryKD2FSH201-937-530673Sent from my Verizon,
Samsung Galaxy smartphone
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
