Fred says "Optionally, you can use the KX3 Utility to monitor an
extended display of characters sent from the KX3's keyer." I assume
"keyer" could refer to the paddle connected to the KX3.
I can type characters into the Utility Terminal lower window and
Transmit the CW. The characters sent are displayed in the top window.
david
KC1DNY
On 12/31/2019 7:48 PM, Ingo Meyer, DK3RED wrote:
Hello David,
I'm enjoying and getting a lot out of our CW discussion. I've tried
to use the KX3 uUtility for practice sending CW.
p. 60 of Fred Cady's big, excellent Elecraft KX-Line book says I
shouldbe able to use the Terminal window of the Utility to display
the text of the CW I'm sending, but I've never been able to get it to
work.
Any ideas?
I use the "Terminal Window" of "Elecraft KX3 Utility" for typing CW
via keyboard.And the characters sent are displayed.
But I can't decode characters given with the key. Only via keyboard -
butthat was not your intention. Did Fred Cady write if they were the
characters entered with a key or with a keyboard?
73/72 de Ingo, DK3RED - Don't forget: the fun is the power!
www.qrp4fun.de - [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
