Clay,
If you get this message, your GND connection may not be ok. I too had
this problem when installing the transverter on my "old" K3. Remember
the +12V will be delivered by a single wire, the GND comes from the side
plate of the K3 which *must* be sanded, which was not the case on mine.
Also, check that the XV's housing is not sitting on any other parts
further down.
hth
73 Gernot DF5RF
Am 12.01.2020 um 18:33 schrieb Clay Autery:
1) I can never GET to transmit on 2 meters. It goes into "HI CUR"
within seconds after switching to the 2 meter band.
2) The receive voltage is 14.3 VDC, and about 1.49-1.51 Amps.
3) The power cord is a custom-made 8AWG, twisted-pair cable directly
lugged to an Astron VS-50M and plugged directly into the K3s. Cable
is less than 2 feet long.
4) It has been working like this for years. SubRX install went
without a hitch.
5) Radio is FULLY calibrated...
I have checked every single TMP cable, plug, et al on the interior and
exterior... Checked cables for pinching. Checked everything I can
think of at least a dozen times.
73,
______________________
Clay Autery, KY5G
(318) 518-1389
On 01/12/20 08:59, Don Wilhelm wrote:
Clay,
Have you measured the voltage displayed by the K3S during transmit?
A low voltage is a common cause for Hi Curr.
Reduce the voltage drop in the power cord by running directly from
the power supply (no DC distribution boxes) and make certain all
connections are tight.
73,
Don W3FPR
On 1/12/2020 6:11 AM, Clay Autery wrote:
OK... so NONE of that worked... So, I reinstalled everything and
checked it 3 times...
Here is something....
What should the voltage be on Pin #1 of P95 (XV12DC) be with respect
to chassis?
I am reading 13.75 VDC
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
