I use an audio spectrum display - Spectrogram - to fine tune a barely there weak signal. Set tuning rate to 1 Hz - the APF peak is less than 10 Hz. Set the frequency cursor in Spectrogram to your pitch frequency. Set the DSP bandwidth wide so the NR works effectively ~ 700 Hz. Use NR mode ~m5-3 so the APF has some unprocessed signal to work on. It takes practice but works.
73, Brian, K0DTJ > On Feb 11, 2020, at 18:05, [email protected] wrote: > > Would anyone be willing to offer suggestions/recommendations? > Your setup of the K3s to maximize weak signal cw reception? > I especially would like to figure out how to maximize the APF without ringing. > > Sincere thanks > Duane > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
