Thank you Bob! Yes I see it - its the "RF Front End + Calibration dialog box". And the "LO Freq Cal"
I've got it setup correctly now Thanks! Duane On Thu, Feb 20, 2020, at 4:26 PM, Bob McGraw K4TAX wrote: > You will need to correct the frequency errors using HDSDR calibration > mode. There is a setting for each mode. It is in the Setup menu under > input calibration. > > Bob, K4TAX > > > Sent from my iPhone > > > On Feb 20, 2020, at 3:26 PM, [email protected] wrote: > > > > So last week with your help I got HDSDR setup to control both a RFSPACE-IQ > > (for panadapter) and the K3 at the same time. > > > > There is one behavior I haven't been able to figure out. > > > > I have HDSDR and the K3 both setup to output a CW sidetone at 600hz. > > > > In CW mode - HDSDR displays a close-up of a given signal on the lower-right. > > And at dead-center its spot on - and producing the 600z tone. > > But its then not quite spot on - on the K3 > > > > I've tried offsetting the side-tone frequency on HDSDR - thinking I just > > needed to shift it so that when the K3 is spot on - the signal will show up > > in dead center on the HDSDR signal window. > > > > But that doesn't seem to work. It still retains the exact same frequency > > offset between HDSDR and the K3 > > > > Has anyone seen this? > > And can suggest a fix? > > > > Thanks > > Duane > > > > ______________________________________________________________ > > Elecraft mailing list > > Home: http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/mmfaq.htm > > Post: mailto:[email protected] > > > > This list hosted by: http://www.qsl.net > > Please help support this email list: http://www.qsl.net/donate.html > > Message delivered to [email protected] > > > > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
