I have used a rubberized mat material designed for lining kitchen shelves to keep keyer paddles in place. That may work for a P3 as well. Something like “gorilla grip”. There are a number of choices.
73 de Dick, K6KR > On Feb 20, 2020, at 09:02, [email protected] wrote: > > I recently obtained a P3 and I'm and exceedingly happy! Now that I own it I > feel bad that I wasted a few years trying other solutions that introduced > noise and undue complexity into my station. > > Just a few notes and questions because the manual is helpful but I don't > fully understand what I'm reading yet. > > > > 1. When using QSY the P3 unit often slides. How do most of you prevent > the unit from sliding? > 2. The signal/noise floor jumps a lot and I'm not sure if that's due to > local interference or something in my setup. Based on reading I likely need > to noise troubleshoot/filter my station. I don't see an AGC setting for the > P3. Any suggestions? > 3. What serial number requires the mod? My serial is 3251 > 4. I need a serial port screw stud - can I buy that from Elecraft when > I purchase a cable + vga card? > 5. Is there a quick setup cheat-sheet anyone has for the P3? > > > > Thanks in advance > > > > > > Jerry Moore > > AE4PB > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
