I've long been aware that my KPA1500 would not run at full power (1.5
kW) unless the SWR was very low. (This is SWR at the input to the ATU,
if used.) The current ATU firmware does a pretty good job of keeping the
SWR below about 1.3:1, which usually is low enough.
In any case, I just ran a simple test on 160, where I have an antenna I
can easily tune to 1:1, or deliberately higher. The ATU was engaged, but
it's settings were not changed during the test. The SWR indicated was
that at the ATU input (amplifier output). I found that the output power
remained nearly constant up to 1.4:1, but the current increased from 58
to 62 A. (This with no adjustment of the K3 power, though the indicated
input power varied slightly.) At 1.5:1, the current exceeded 65 A and
the amplifier faulted. By reducing drive, I was able to run it at 1.4 kW
output and 60 A.
The above is typical of my experience on other bands, etc. The effect of
SWR on the amplifier, of course, depends on the actual impedance at the
amplifier, so in some cases it may be more or less sensitive to SWR.
Do others see similar effects?
73,
Scott K9MA
--
Scott K9MA
[email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
