Mike - are you using Data-A mode? When I put my K3 into Data-A mode, the RF scale becomes the ALC scale.
Jim Bennett / W6JHB Folsom, CA > On Apr 5, 2020, at 7:11 PM, KE0KAC <[email protected]> wrote: > > I'm stuck trying to understand why I can't get any ALC bars when I'm using > fldigi. I can connect headphones to the line that normally goes into the > MIC connector and can vary the volume from complete silence to very loud so > I know a signal is making it to the MIC jack. If I plug my MH3 microphone > into the MIC jack and speak, I see the bars vary depending on how loud I > talk. > > A question - when fldigi puts the KX3 into transmit and send data, should > the RF scale disappear and be replaced by the ALC scale? Sometimes (like > right now) I don't see the ALC scale BUT I see bars above the RF scale that > I can vary using the MIC knob. What causes the ALC scale to show up? > > By the way, my KX3 is connected to a KXPA100 which the manual indicates has > an ALC adjustment screw. Is the KXPA100 controlling some of this? > > Mike, KE0KAC > > > > -- > Sent from: http://elecraft.365791.n2.nabble.com/ > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
