New to the K3. This is a used K3 but in good shape. I downloaded the current firmware as it was down several levels.
The rig has been idle for a few months. The 100 watt board is installed. I went through the parameters trying to set it for high power. However, every time I attempt to adjust power it only goes to 12 watts and then a relay clicks in the rig and no power output. It does TX at the low power level, no problem. Just no high power between the 12 watts and 100. thanks, 73 Bill K3SV ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
