If it’s a regulated power supply with crowbar And the radio has a fuse why are 
you using inline fuses?

Sent from my iPhone

> On Apr 25, 2020, at 10:04, Chuck Chandler <[email protected]> wrote:
> 
> Here's an update.
> 
> I replaced the power cable running from the powerstrip with a 3-foot length
> with glass fuse holders in each leg.  I also adjusted the power supply to
> 14.50V at rest.  The K3S now shows 14.2V at rest.  At 100W TX the K3S shows
> 13.2V, so a 1 volt drop.  Way too much.
> 
> The power supply voltage measured at the terminals drops from 14.50 to
> 14.44 for full power TX.  This seems too much, I had read the drop should
> be no more than 0.01V and this is 0.06V.
> 
> So, suspecting the in line fuse holders I made up another cable with dual
> blade-fuse holders, which was worse.  TX voltage on the K3S display dropped
> to 12.9V.
> 
> I'm suspecting my power supply is to blame - it's a TenTec 963, a
> re-branded Astron SS-30.  Alternatively, I have another commercial power
> cable with fuse holders I can cut down and try.
> 
> Many thanks for all the help both here on the reflector and the direct
> emails from several fellows, and to Rich VE3KI for the on-air tests this
> morning!
> 
> 73 de Chuck, WS1L
> 
> -- 
> 
> 
> ===================
> Chuck Chandler
> [email protected]
> ===================
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[email protected]
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to [email protected] 
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected] 

Reply via email to