I had been in conversation with Elecraft Tech Support, but I have not
heard back from them in three weeks. So I will throw this out to the
group.
It appears that there is an error in the KRC2 manual and it is not shown
in the Errata sheet.
On page 24 the manual states the following when connecting the KRC2 to
an Icom radio:
"For this reason it is recommended that the reference input setup be
used. In this configuration, the band data is connected to pin 9 and the
8 volt reference is connected to pin 4. This mode is set with jumpers
W1, W2 and W3 installed."
Directly below that statement this statement appears which confirms the
first statement:
"• Analog band input on J1/2 pin 9 with reference voltage on J1/2 pin 4:"
If you look at the schematic it shows Pin 9 as Reference voltage (8v)
and Pin 4 ALC (band voltage)
So they are reversed.
Since the wording and the schematic disagree.
Does anybody have any idea which is correct?
My unit is not working properly. I sent it in for repair but 1 hour of
labor is about the cost of the unit. So they returned it and I am
trying to troubleshoot it myself
Rich
K3RWN
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
