Is there any way to power off the fans (or lower their RPM) on the PSU if the amp is in standby mode?
I would like to keep my rig on 6m throughout the day during the Es season. The problem is my 6m antenna is on antenna port 2 on the KPA, which requires the amp to be powered up. I only need to TX when a new grid pops up, but I do like to monitor the band during the day while I'm working. My XYL is working from home, and is in the same room for about 9 or 10 hours a day, and the noise after 10 minutes was too much for her. Any suggestions? Please-n-thanks. --------------------------------------------- 73 and Good DX Peter, W2IRT President, North Jersey DX Association DXCC Card Checker Letter O Manager, ARRL Incoming 2nd District QSL bureau ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
